
LTC2234
5
2234fa
SYMBOL
PARAMETER
CONDITIONS
MIN
TYP
MAX
UNITS
VDD
Analog Supply Voltage
(Note 7)
●
3.1
3.3
3.5
V
OVDD
Output Supply Voltage
(Note 7)
●
0.5
3.3
3.6
V
IVDD
Analog Supply Current
●
191
206
mA
PDISS
Power Dissipation
●
630
680
mW
PSHDN
Shutdown Power
SHDN = High, OE = High, No CLK
2
mW
PNAP
Nap Mode Power
SHDN = High, OE = Low, No CLK
35
mW
SYMBOL
PARAMETER
CONDITIONS
MIN
TYP
MAX
UNITS
fS
Sampling Frequency
●
1
135
MHz
tL
ENC Low Time
Duty Cycle Stabilizer Off
●
3.5
3.7
500
ns
Duty Cycle Stabilizer On
●
2
3.7
500
ns
tH
ENC High Time
Duty Cycle Stabilizer Off
●
3.5
3.7
500
ns
Duty Cycle Stabilizer On
●
2
3.7
500
ns
tAP
Sample-and-Hold Aperture Delay
0
ns
tOE
Output Enable Delay
(Note 7)
●
510
ns
tD
ENC to DATA Delay
(Note 7)
●
1.3
2.1
3.5
ns
tC
ENC to CLOCKOUT Delay
(Note 7)
●
1.3
2.1
3.5
ns
DATA to CLOCKOUT Skew
(tC - tD) (Note 7)
●
–0.6
0
0.6
ns
Pipeline Latency
5
Cycles
TI I G CHARACTERISTICS
U
W
The
● denotes the specifications which apply over the full operating temperature
range, otherwise specifications are at TA = 25°C. (Note 4)
POWER REQUIRE E TS
W
U
The
● denotes the specifications which apply over the full operating temperature
range, otherwise specifications are at TA = 25°C. (Note 8)
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: All voltage values are with respect to ground with GND and OGND
wired together (unless otherwise noted).
Note 3: When these pin voltages are taken below GND or above VDD, they will
be clamped by internal diodes. This product can handle input currents of
greater than 100mA below GND or above VDD without latchup.
Note 4: VDD = 3.3V, OVDD = 1.8V, fSAMPLE = 135MHz, differential
ENC+/ENC– = 2VP-P sine wave, input range = 2VP-P with differential drive,
unless otherwise noted.
Note 5: Integral nonlinearity is defined as the deviation of a code from a
straight line passing through the actual endpoints of the transfer curve. The
deviation is measured from the center of the quantization band.
Note 6: Offset error is the offset voltage measured from –0.5 LSB when the
output code flickers between 00 0000 0000 and 11 1111 1111 in 2’s
complement output mode.
Note 7: Guaranteed by design, not subject to test.
Note 8: VDD = 3.3V, OVDD = 1.8V, fSAMPLE = 135MHz, differential
ENC+/ENC– = 2VP-P sine wave, input range = 1VP-P with differential drive,
output CLOAD = 5pF.